Blade Origin

squashblossom

I use the KNK Zing, and set the blade origin for Print & Cut. I may go through 3 or more sheet cuts, but then on the next sheet my Zing forgets where the blade origin was. I click on 'use last' and it just sits there. So I have to go through setting up the new origin again. What is causing this?

SandyMcC

I'm not sure what causes it... whether it's a bug in MTC or maybe a drop in communication that would cause it.  

squashblossom

So no real fix I guess. I didn't know if it was the Zing or MTC.

SandyMcC

Typically, bugs like this that are submitted get a response back like this, "I can't repeat the issue therefore I cannot resolve it."     It makes sense but is frustrating for the user.