We are running a sale on Popup Card Studio. Save 28% right now during this very limited time sale. Click here to order now!

We are also running a sale if you purchase both Make The Cut! and Popup Card Studio. Save 38% right now during this very limited time sale. Click here to order!

Registration key recovery help needed!

ABuys1ABuys1 Member Posts: 1
edited July 2019 in Help for Make The Cut
I have been trying for the past 5 days to recover my registration key from Make The Cut but to no avail!  I am stressed out and cannot run my business!  I have requested my registration key about 20 times but still have not received it!   PLEASE, PLEASE HELP!
Post edited by Gabe on

Comments

  • MeFlickMeFlick Member Posts: 9,251
    You will probably need to try and reach out to @SBryanW to see if he can help you. His email address can be found on his profile page.

    Second, as much as it pains me to say it, MTC has essentially been abandoned by its creator. So, if I were relying on software to run my business, I would make sure it was being updated and supported still. So I would suggest that you look into purchasing Sure Cuts A Lot (SCAL) and learning it as time permits (and I would make time as I could). Then you will have a choice at least as to what you can use.
    Go Vols!
    image
    Cutting with 18" Silver Bullet and a KNK Force (the rest are collecting dust!)
  • Liz_ALiz_A Member Posts: 10,578
    @ABuys1 - The registration recovery system appears to be still broken, so please direct your request to @SBryanW by sending him a Message from his profile page.
    Still using MTC but slowly migrating to SCAL. KNK cutters including the Force and Maxx Air continue to be my favourites. Fluent in other cutter languages.
  • SandyMcCSandyMcC Member Posts: 7,671
    Here are 5 ways to possibly recover it. Also, if you bought and registered your MTC through KNK USA, you may be able to retrieve it through them as most of the pins they sold had been provided a certain format from MTC so that they received an email when the user registered the software.  But start here first:

    https://www.iloveknk.com/Support/Tutorials/Make-The-Cut/Retrieving-MTC-and-PCS-Registrations.pdf

    Sandy McCauley
    Cutting with KNK Force, Maxx Air, Zing Orbit, Skycut C and D
    Over 90 free MTC videos: http://www.iloveknk.com/support/mtc-support/
    Latest MTC User Manuals: http://www.iloveknk.com/Support/user-manuals/
Sign In or Register to comment.

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!