We are running a sale on Popup Card Studio. Save 28% right now during this very limited time sale. Click here to order now!

We are also running a sale if you purchase both Make The Cut! and Popup Card Studio. Save 38% right now during this very limited time sale. Click here to order!

KNK Force @ Sandy

MendyRapaCatMendyRapaCat Member Posts: 481
Hi Sandy! I haven't tried PNC in SCAL 4 Pro until now. When I try to set my second registration mark it goes to the side and flashes red. What am I doing wrong? Thanks for helping!
I love my 24" Blackcat and my Cameo!

Comments

  • SandyMcCSandyMcC Member Posts: 6,977
    Your first mark is too far to the right when it is set. What happens is that after you're setting the first mark in the upper left corner, the head is then moving to where it thinks the second mark should be (based on where you set the first one). If you set the first one too far to the right, then the head will then try to move too far to the right of that... and end up out of range.  What I do is this... I make sure that when I put the printout onto the mat, the  head will need to be moved a few inches to the left in order to get the blade holder in the right spot for that first camera image.  Then you'll be fine. 

    I sure hope this makes sense!  My writing is off today!  lol  
    Sandy McCauley
    Cutting with KNK Force, Maxx Air, Zing Air
    Need help with your KNK? Visit this link: http://knkusa.com/contact/
    KNK / MTC Videos: http://bit.ly/1kmAcoO
    Latest KNK / MTC User Manuals: http://www.iloveknk.com/Support/user-manuals/
  • MendyRapaCatMendyRapaCat Member Posts: 481
    Ok, thank you Sandy! I will try that!
    I love my 24" Blackcat and my Cameo!
  • MendyRapaCatMendyRapaCat Member Posts: 481
    Ok, sorry, another question. Do you have to print in landscape?
    I love my 24" Blackcat and my Cameo!
  • MendyRapaCatMendyRapaCat Member Posts: 481
    Duh! Figured it out! I was putting it in upside down! Lol!
    I love my 24" Blackcat and my Cameo!
Sign In or Register to comment.